Keyboard macros enable a sequence of commands to be turned into a single operation. For example, if it is found that a particular sequence of commands is to be repeated a large number of times, they can be turned into a keyboard macro, which may then be repeated the required number of times by using Prefix Arguments.
Note that keyboard macros are only available for use during the current editing session.
Arguments: None
Key sequence:
Ctrl+X Shift+(
Begins the definition of a new keyboard macro. All the commands that are subsequently invoked are executed and at the same time combined into the newly defined macro. Any text typed into the buffer is also included in the macro. The definition is ended with
End Keyboard Macro, and the sequence of commands can then be repeated with
Last Keyboard Macro.
Arguments: None
Key sequence:
Ctrl+X Shift+)
Ends the definition of a keyboard macro.
Arguments: None
Key sequence:
Ctrl+X E
Executes the last keyboard macro defined. A prefix argument causes the macro to be executed the required number of times.
Arguments:
name
Key sequence: None
editor:name-keyboard-macro-command
p
&optional
name
Makes the last defined keyboard macro into a command called name that can subsequently be invoked by means of Extended Command.
Arguments:
action
Key sequence:
Ctrl+X Q
action
During the execution of a keyboard macro, this command prompts for an action. It is therefore possible to control the execution of keyboard macros while they are running, to a small extent.
The following actions can be used to control the current macro execution.
Continue with this iteration of the keyboard macro and then proceed to the next.
Skip over the remainder of this iteration of the keyboard macro and proceed to the next.
Exit from this keyboard macro immediately.